Welcome, Guest. Please login or register.
November 14, 2019, 01:37:45 pm

Login with username, password and session length
TRADER Feedback System
IS NOW AVAILABLE
* SBFTECH Membership Required *
435293 Posts in 37285 Topics by 9537 Members
Latest Member: Mgabski
Search: Advanced search
Advertiser Inquiries
+ My Community
|-+ Grass Roots Tech
| |-+ Grass Roots General Tech
| | |-+ torque to yield rod bolts?
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: torque to yield rod bolts?  (Read 4821 times)
93reefblueGT
Stroked Small Block
****
Offline Offline

Posts: 426

Location: Rockford, IL

« on: November 27, 2016, 10:18:19 am »

I got a question on torque to yield bolts, if these bolts a a one time stretch/torque bolt and you are going to install new factory sized bearing and you want to measure clearance how is the proper way of going bout this? If you checked clearance with the old bolts and it doesn't clamp like the new ones you would think the clearance could change. If you check with the new bolts then the torque to yield is done... so do you have to buy 2 sets to check properly lol, shit if the clearances are off that would get $ fast.
Logged
knucklefux
Adv_SBFTechie
Big Block
****
Offline Offline

Posts: 4388


Location: leesburg, ga

« Reply #1 on: November 27, 2016, 10:50:56 am »

You can use the old bolts to check clearances.

But rather than buy new tty bolts, I'd just get arp stuff to replace them...
Logged

95 gt-R.I.P.
2004 cobra-needs more boost
93reefblueGT
Stroked Small Block
****
Offline Offline

Posts: 426

Location: Rockford, IL

« Reply #2 on: November 27, 2016, 11:37:38 pm »

I don't need a arp bolt because this is on a bolt on 4.6 motor and i dont want to change the clamp load from a factory bolt the a stronger arp and might change the big end of the rod and need to be resized with a arp.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  



Powered by MySQL Powered by PHP Valid XHTML 1.0! Valid CSS!
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines



408 Stroker