Welcome, Guest. Please login or register.
November 22, 2018, 06:53:03 am

Login with username, password and session length
TRADER Feedback System
IS NOW AVAILABLE
* SBFTECH Membership Required *
435277 Posts in 37275 Topics by 9537 Members
Latest Member: Mgabski
Search: Advanced search
Advertiser Inquiries
+ My Community
|-+ Membership Tech
| |-+ Product Reviews
| | |-+ proform oil pan
0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: proform oil pan  (Read 1760 times)
joey11
Big Block
*****
Offline Offline

Posts: 847


Location: maryland

« on: October 03, 2009, 08:46:25 pm »

any use these pans? did you have any fitment issues? i got one and the side of the pump hits the back side of front sump of the pan causing the bolt holes to not line up. thinking maybe i got a defective one. it's a 68a melling pump on a 91 302 block.
Logged

1987 lx
old 306,stock bottom end(RIP!!!)
NEW SETUP / 331 with scat chp kit, tw 205's, FTI TLSR, super victor, c4 w/brake,ucc 5300 stall, 4:10's,pro-systems carb. 
times TBD.......
moco
Stroked Small Block
****
Offline Offline

Posts: 385


Location: Keller,Tx.

« Reply #1 on: October 03, 2009, 09:28:33 pm »

I just installed one on my 347 and had the same issue. All the bolt holes lined up except the front ones, I tapped on the side of pan with a rubber mallet and I was able to shift the pan and line up the bolt holes with a punch. It wasn't off much so I didn't have much of a problem. Good luck.
Logged
joey11
Big Block
*****
Offline Offline

Posts: 847


Location: maryland

« Reply #2 on: October 04, 2009, 07:50:10 pm »

i got it to fit, i had to grind off the tab that was hitting the pan. it was a useless part on the pump
Logged

1987 lx
old 306,stock bottom end(RIP!!!)
NEW SETUP / 331 with scat chp kit, tw 205's, FTI TLSR, super victor, c4 w/brake,ucc 5300 stall, 4:10's,pro-systems carb. 
times TBD.......
Pages: [1] Go Up Print 
« previous next »
Jump to:  



Powered by MySQL Powered by PHP Valid XHTML 1.0! Valid CSS!
Powered by SMF 1.1.21 | SMF © 2015, Simple Machines



408 Stroker