My Community

General Tech => Aftermarket Tuners - Generally => Topic started by: FORDTRUCKS79 on May 28, 2016, 08:23:24 pm



Title: Microsquirt 3 tuning issue NEED HELP
Post by: FORDTRUCKS79 on May 28, 2016, 08:23:24 pm
Installed kit with adapter harness to go to my 88 mustang harness , tuned through tuner studio , TPS, ECT, IAT were calibrated won't start unless my foot is on gas pedal and when it starts it loads up , pull fuel pump relay and start car back up and rev it a few times before it stalls ???? Yes I have 30lb high impedance injectors , Any help would be greatly appreciated !!!!


Sent from my iPhone using Tapatalk


Title: Re: Microsquirt 3 tuning issue NEED HELP
Post by: knucklefux on May 28, 2016, 10:53:10 pm
I never was able to get megasquirt working properly in my ride, so take this with a pound of salt:  seems like your ve table needs adjusting.

Can you datalog with microsquirt?  Are you using a wideband?  If so, what does your afr look like?


Title: Re: Microsquirt 3 tuning issue NEED HELP
Post by: FORDTRUCKS79 on July 04, 2016, 12:52:12 pm
Got it running and driving now just gotta get spark advance table right , any suggestions ????? Ganna end up around 38 total timing


Sent from my iPhone using Tapatalk


Title: Re: Microsquirt 3 tuning issue NEED HELP
Post by: bender460 on July 05, 2016, 01:32:52 pm
  Post your tune and I'll have a look.